Español
English
Français
Low impedance amplifier with 4 Ω 20 W output, controllable locally via 1206 keyboard or remotely via 1202 console or 0801 control software. It controls one zone, with the possibility of controlling up to a maximum of 32 loudspeakers, distributing a total power of 10+10W or 20 W. The music programme can be chosen and the playback volume can be adjusted for each zone via any 1202 console. Via the PIN input a local audio signal from a 1105, 1107 or 1106 can be connected. Front LEDs to indicate the status of the audio output (yellow), setup (red), and ON/OFF (green). Front setup pushbutton. 14-Way ribbon wire socket for connection to audio transmission bus. Rear 14-way flat cable strap and female connector. Rear plug-in strip with 9 terminals. Rear cable with 15 V— power connector.
1304.1A
1-Zone (10 + 10 W) / 20 W mono amplifier with digital control
Low impedance amplifier with 4 Ω 20 W output, controllable locally via 1206 keyboard or remotely via 1202 console or 0801 control software. It controls one zone, with the possibility of controlling up to a maximum of 32 loudspeakers, distributing a total power of 10+10W or 20 W. The music programme can be chosen and the playback volume can be adjusted for each zone via any 1202 console. Via the PIN input a local audio signal from a 1105, 1107 or 1106 can be connected. Front LEDs to indicate the status of the audio output (yellow), setup (red), and ON/OFF (green). Front setup pushbutton. 14-Way ribbon wire socket for connection to audio transmission bus. Rear 14-way flat cable strap and female connector. Rear plug-in strip with 9 terminals. Rear cable with 15 V— power connector.
Do you have questions about this product? Contact our support:
sat_consultas@egiaudio.com
Amplifier to control one zone. It will be able to manage up to 32 loudspeakers and will share out a 20 W total power output. Audio program selection and volume level regulation from any 1202 console. A local audio signal (from 1105 + 1107 or 1106) can be connected through a PIN inlet. Voice messages priority when emitted from 1202, 1103.1 or 1104.1. A digital control keypad 1206 connected to terminal blocks T, L and 4 will enable a local control of the zone. The amplified audio output can be configured as a single 20 W or double 10 + 10 W. This configuration is set automatically depending on the connected loads (speakers). ONLY ONE CONFIGURATION CAN BE USED. Aluminium. Technical data
- Power supply 15 V
- Current consumption (@ max. power) 1.9 A
- Current consumption (@ typ. power) 1.15 A
- Rack units 7 UP; 3 UA no speakers Connexion Min. impedance 4 Ω 16 Ω 32 Ω 20 W 4 Ω 1 4 8 10+10 W 2 Ω 2+2 8+8 16+16
1304.1A
No customer reviews for the moment.